· 1, Location: Suffolk. Country: Has anybody got a Installation Programming Manual for the AQ Control, I've got one which isn't working properly, I don't think there is anything wrong with it, But there is no manual on site and I can't remember the full programming sequence. Any help would be graterfully recieved! Boilerman2, 6 Nov My plan was to remove the original programmer and controller and let the tado control the system. Currently there is an AQ used to program the system. A central controller is located next to the hot water tank and diverter valve a short distance away along with the pump. This controller sends output to command the boiler on/turn on pump etc. product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option). If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or (ii) call Honeywell Customer Care at Customer Care will make the.
Installation Guide This manual covers the following models • THU For up to 3 Heat/2 Cool heat pump or up to 2 Heat/2 Cool conventional systems with dehumidification, humidification, or ventilation Honeywell International Inc. US Patent No. , D and other patents pending. Share: 1 Press and hold Menu and + buttons for approximately 5 seconds to enter advanced menu. 2 Press Select to enter System Setup (ISU) menu. 3 Press Select to cycle through System Setup numbers. 4 Press + or - to change values or select from available options. 5 Press Select to save changes and advance to the next System Setup number. Install EIM Install return air sensor (optional) Install sensor on return air duct at least 12" (mm) upstream from ventilator, humidifier or dehumidifier (do notmount downstream) Drill 1/4" hole (mm) The return air sensor maintains safe indoor temperature if thermostat power is lost.
Currently there is an AQ used to program the system. A central controller is located next to the hot water tank and diverter valve a short distance away along with the pump. This controller sends output to command the boiler on/turn on pump etc. All wiring comes back to this central controller box. The current programmer is connected to to. Series Installation Instructions Programmable Digital Thermostat M Wallplate installation Remove the wallplate from the thermostat, then follow directions below for mounting. 1. Remove battery holder. 2. Pull here to remove wallplate from new thermostat. 3. Pull wires through wire hole. 4. Position wallplate on wall, level and mark hole. Honeywell AQ Installation { 1 Comment } The AQ is an outside temperature compensator system for use in domestic properties and can be used on new installations or to upgrade existing systems, making use of existing valves that may be www.doorway.ru AQ is available in three packs – an Upgrade pack, a Standard pack or a Modulating.
0コメント